The 21' and under 70+ mph Boat pic thread

[poncho]

Turned out great!
I might come down and get a few measurements.
I did some machining on the transom bar and a few other parts for Mike when he switched to the center plate.
Didn’t keep any of the numbers though.
Also, need to call your Dad and find out where he got the Injector Ram Tubes done on the Litchfield, been a few years now since it was built…I know he told me.
Always liked them and would like to do the same on a project I have going.

View attachment 1477848 View attachment 1477847

Porn

 

[@BigRedBryan13]

How did she run?

It ran great, had to make a gear and chip change but it did good.

 

[Wiseone1]

Turned out great!
I might come down and get a few measurements.
I did some machining on the transom bar and a few other parts for Mike when he switched to the center plate.
Didn’t keep any of the numbers though.
Also, need to call your Dad and find out where he got the Injector Ram Tubes done on the Litchfield, been a few years now since it was built…I know he told me.
Always liked them and would like to do the same on a project I have going.

View attachment 1477848 View attachment 1477847

Come down anytime to take some measurements the boat is at my house in Alpine. A few mikes from where you got that wood litchfield I believe

 

[TrollerDave]

It ran great, had to make a gear and chip change but it did good.

I’m assuming it was 70+. I’d hate for you to have to delete the post.

 

[@BigRedBryan13]

I’m assuming it was 70+. I’d hate for you to have to delete the post.

Haha just a little bit over, but not much. Haha