Search results

How much does one of those cost to have built?

Buy a gun with a 2.5 mil tip off of Amazon. Thin with up to ten percent styrene. Or mix 50/50 duratec to gel and it will shoot out of any hvlp gun.

@old rigger I'm going to use surfacing agent. Ok so I spray all of my pigmented base gelcoat graphics let them cure sand with 400grit wipe with acetone and then spray the clear to cover the boat

@old rigger after each graphic color cures and i tape to put on the next color do I sand them all after they cure to spray on the clear?

So I spray color gel apply clear to each graphic color and then sand the tape lines to blend?

After doing some math it looks like these springs will be more like 340lbs of pressure at .550 lift. They are 400 at 1.2 and have an installed height of 1.9. seat pressure at 1.9 is 110.

Also what about the stock rockers?

@obnoxious001 comps recommendation for the springs was about 350 open and I added a bit of pressure for the turbos.

Will a stock gen 6 roller lifter withstand 400lbs of open valve spring pressure and 5800-6000 rpm? Cam is a comp 01-451-8.

Is this still available?

I plan on regelcoating my Fountain In the next couple of weeks. It will have some designs in the gelcoat. Im going to use clear gelcoat over the top of the gelcoat. My question is prep for Clear gelcoat. What is the correct method for spraying clear gelcoat over freshly sprayed gelcoat? Should...