WANTED: REAL DEAL BBC - 19' Schiada V-Drive V-Hull Project

[jayteetrotter]

Will consider all serious offers!

http://www.riverdavesplace.com/forums/showthread.php?t=41743&page=3

Motor Wanted for a worthy project. The boat is going in for Gel tomorrow and will be ready for a new power plant. The motor is officially shot. Used my own .40 cal sig sauer...lol

MOTOR WANTED>.. Here is the deal, all power options will be considered. Only want to talk to serious sellers since I am a serious buyer.

All avenues considered... Parts, Short Block, Long Block, Complete build. PM me and let me know what you have and lets get serious and your motor can be in the boat! That's a deal all in itself. Think of the nostalgia, the history. See below:

 

[DOSBOOT]

noticed your thread for motor wanted while looking at INTHERED's twin turbo motor. Not sure if it's what your looking for but since your in project mode anyway I thought I would put it out there. I have a 540ci Gen 6 BBC built by WPM that was in my 26' cat. All the good stuff, JE pistons, Eagle rods, crane cam and lifters, and ported GM aluminum bow tie heads, etc, etc. Made roughly 600hp. It decided to break a valve at the end of the season. Boogered up the head but fixable, did a number on the piston and some damage to the cylinder wall. At this point have only pulled off the head but I don't think the rod is damaged. The whole motor should really be gone through as it's 8 years old. The hours are low, about 160 but age is age. The motor ran very strong and pushed this boat to just over 90mph spinning a 30p prop on a bravo drive with a stand off box. I have pictures on my profile of the motor.

I'm considering something like INTHERED's twin turbo motor to replace it and would be willing to make a good deal on it. If your interested in doing the motor work yourself you could have yourself a nice fresh set up pretty cheap. Let me know if your interested.

 

[jayteetrotter]

noticed your thread for motor wanted while looking at INTHERED's twin turbo motor. Not sure if it's what your looking for but since your in project mode anyway I thought I would put it out there. I have a 540ci Gen 6 BBC built by WPM that was in my 26' cat. All the good stuff, JE pistons, Eagle rods, crane cam and lifters, and ported GM aluminum bow tie heads, etc, etc. Made roughly 600hp. It decided to break a valve at the end of the season. Boogered up the head but fixable, did a number on the piston and some damage to the cylinder wall. At this point have only pulled off the head but I don't think the rod is damaged. The whole motor should really be gone through as it's 8 years old. The hours are low, about 160 but age is age. The motor ran very strong and pushed this boat to just over 90mph spinning a 30p prop on a bravo drive with a stand off box. I have pictures on my profile of the motor.

I'm considering something like INTHERED's twin turbo motor to replace it and would be willing to make a good deal on it. If your interested in doing the motor work yourself you could have yourself a nice fresh set up pretty cheap. Let me know if your interested.

PM sent.