Pentair power center failure

[Trim it up]

Looks like my Pentair Intellichlor power center took a dump. I changed the fuse holder and fuse and it’s not powering on so my salt chlorinator isn’t working. Anyone have a good electrician that can diagnose or swap out and install a new one? Thanks

 

[185EZ]

Check the small rocker circuit breaker on the main panel.
Usually at top right on panel

 

[Melloyellovector]

Is it connected to IntelliCenter or just intellichlor transformer box
how old is unit?
IntelliCenter, check manual reset top right
intellichlor internal fuse
if intellichlor only, when you power on do you hear the transformer make a noise like a light booong, then the slightest buzz sound. If so transformer working and cell bad
double check cord from salt cell to panel. Dogs, rats, and gardeners have been known damage cords
if connected to intellicenter or ez touch control etc, open panel and follow power wires up to relay, they can fall out from connectors on relay, and lose power to cell

if all checked above and if its older than 7 years old, likely save your money paying to diagnose plus repairs. At that point replace with new, and have a warranty

 

[Trim it up]

It’s going on its ninth year. It’s hooked up to an easy touch control panel. I’ll look into your suggestions. Might just be time for a new one. Thx

 

[Melloyellovector]

It’s going on its ninth year. It’s hooked up to an easy touch control panel. I’ll look into your suggestions. Might just be time for a new one. Thx

Likely bad cell, if replacing look at ic40 to get the most life out of it

 

[Joker]

Likely bad cell, if replacing look at ic40 to get the most life out of it

I've got that brand new IC40 for sale. Just sent him a PM.