Need motor pulled

[Rbcconst]

I have a 502 in an eliminator 28 eagle I need pulled. Who can pull it and put it back when I'm done rebuilding.

 

[Rbcconst]

I am in so cal in the redlands area.

 

[wsuwrhr]

We can pull it at the shop in Upland and put the engine in the back of your truck if that will help.

Brian

 

[wsuwrhr]

The weekend would work much better for a boat that big.

Today/tomorrow while no one is in the parking lot and while the weather is cooler.

 

[wsuwrhr]

....are you asking for help with a forklift and/or labor, or someone to do it completely?

 

[Trash]

Just another option. I built a gantry out of lumber and used a 1 ton chain fall. Worked like a champ. Cut the wood up when done and had some firewood.

 

[Rbcconst]

Just another option. I built a gantry out of lumber and used a 1 ton chain fall. Worked like a champ. Cut the wood up when done and had some firewood.

I'm looking for someone to disconnect it from the boat and take off all the marine boat stuff. Also need them to put it all back together after the re build.

 

[wsuwrhr]

I'm looking for someone to disconnect it from the boat and take off all the marine boat stuff. Also need them to put it all back together after the re build.

Sorry I couldn't help with that. Too much liability. If you change your mind, Im down to help you get it out.

I would think whomever is building the motor is going to want a hand in putting it back in.

Brian

 

[Runs2rch]

I'm looking for someone to disconnect it from the boat and take off all the marine boat stuff. Also need them to put it all back together after the re build.

Dude if you have zero knowledge take it to a reputable shop and let them handle it start to finish.

 

[copterzach]

I can. But it will be haul for ya. South Texas

 

[wsuwrhr]

Dude if you have zero knowledge take it to a reputable shop and let them handle it start to finish.

Im pretty sure Brian from B&D can do exactly this.

 

[Rbcconst]

Dude if you have zero knowledge take it to a reputable shop and let them handle it start to finish.

I have a motor machine/engine builder but he doesn't take motors out or put them in. Im wanting to have someone disconnect the motor, take it out then put it back in when I am done having it re built.

 

[28skater]

Prime Marine
10742 Edison Ct. Rancho Cucamonga, CA 91730

Owner
Mike Ramirez
Fabrication Supervisor::
Mike King



Hours:
M-F 9:00 AM - 5:00 PM PST
Tel:
(909) 484-8338

Fax:
(909) 484-8331