My Crusader Remodel

No Butt No Putt · Nov 24, 2014

So last year I had numerous electrical problems. So this year I said f*** it. I ripped ever wire and hose out of the boat. Last week was the start.
Today I filled old holes, sanded, sanded, and sanded some more, then painted the bilge with Bilgekote. 2 coats so far. Got the carpet in today, also wired up the system. No more head unit. Just a headphone jack to the amp. Here's the pics so far.

ImageUploadedByTapatalk1416790365.999508.jpg

ImageUploadedByTapatalk1416790379.873562.jpg

ImageUploadedByTapatalk1416790390.729159.jpg

ImageUploadedByTapatalk1416790418.178199.jpg

ImageUploadedByTapatalk1416790428.633316.jpg

ImageUploadedByTapatalk1416790438.237143.jpg

t&y · Nov 24, 2014

Nice. That carpet makes a huge difference. Are you changing the interior lay out?

No Butt No Putt · Nov 24, 2014

t&y said:
Nice. That carpet makes a huge difference. Are you changing the interior lay out?

No. It has 2 buckets and a bench now and they are in great shape.

Mainly just bilgekote, carpet, re-wire, re-plumb, and rail kit. I'm using all ss braided lines.

No Butt No Putt · Nov 25, 2014

Widowmaker got started on the wiring today.

ImageUploadedByTapatalk1416880348.555695.jpg

No Butt No Putt · Dec 14, 2014

Rails are in, side panels installed with new billet washers. Battery tray is almost done.

No Butt No Putt · Dec 14, 2014

ImageUploadedByTapatalk1418526183.590351.jpg

ImageUploadedByTapatalk1418526192.079561.jpg

ImageUploadedByTapatalk1418526201.300298.jpg

LuckyDaze · Dec 19, 2014

Looks great!

t&y · Dec 19, 2014

Looking good. Are you going to try to keep it modular so you can take it all out if needed? Or is it just more of an easy install thing mounting the MSD and fuse block stuff all on the same panel?

No Butt No Putt · Dec 19, 2014

t&y said:
Looking good. Are you going to try to keep it modular so you can take it all out if needed? Or is it just more of an easy install thing mounting the MSD and fuse block stuff all on the same panel?

It will be easy to remove if needed. But the main reason I did it this way was if there's a short or something is not working. You only have 2 places to look. The main panel or the fuse block that's going under the dash. I'm not using a bus terminal on the back of the engine anymore. Or the giant starter relay on the back of the engine. Everything is waterproof and in 2 locations.