WELCOME TO RIVER DAVES PLACE

Harbor freight generator 4000 questions

BIGRED9158

Well-Known Member
Joined
Jan 1, 2020
Messages
2,873
Reaction score
5,911
So I let the generator sit sense last thanksgiving tried to fire it up the other day would not start. I drained the gas put fresh gas and did an oil change. It will no start for about 5-8 seconds with some starting fluid spray then dies going to pull the carb has anyone replaced a carb on one of these if so which one are you going with I see a few replacements on Amazon
 

monkeyswrench

To The Rescue!
Joined
Sep 7, 2018
Messages
29,064
Reaction score
82,512
Honestly, pull the float bowel and carb clean the needle and seat, and the main jet. The new gas sucks balls, but gets the varnish still that will stick the float.

About this time of year I end up doing a bunch of genny's...same people every year. They all say they'll start them every month...
 

LargeOrangeFont

We aren't happy until you aren't happy
Joined
Sep 4, 2015
Messages
49,689
Reaction score
76,178
So I let the generator sit sense last thanksgiving tried to fire it up the other day would not start. I drained the gas put fresh gas and did an oil change. It will no start for about 5-8 seconds with some starting fluid spray then dies going to pull the carb has anyone replaced a carb on one of these if so which one are you going with I see a few replacements on Amazon

Once you get the carb cleaned or swapped drain the bowl after use if it has a provision for it. If not add a fuel shut off valve to the supply line and run it out of fuel after each use. Or do both, shut off the supply and drain the bowl, run it out of fuel.

Should solve yore problem forever.
 

Yldboyz

Well-Known Member
Joined
Sep 3, 2009
Messages
5,717
Reaction score
2,801
Once you get the carb cleaned or swapped drain the bowl after use if it has a provision for it. If not add a fuel shut off valve to the supply line and run it out of fuel after each use. Or do both, shut off the supply and drain the bowl, run it out of fuel.

Should solve yore problem forever.
LOF couldn't of said it better. Always run the gas out of the carb and fuel line when you store your equipment. This will save you a headache.
 

BIGRED9158

Well-Known Member
Joined
Jan 1, 2020
Messages
2,873
Reaction score
5,911
Once you get the carb cleaned or swapped drain the bowl after use if it has a provision for it. If not add a fuel shut off valve to the supply line and run it out of fuel after each use. Or do both, shut off the supply and drain the bowl, run it out of fuel.

Should solve yore problem forever.
Yeah I know thats what I always do but this time I forgot to turn the fuel off and run it dry
 

BIGRED9158

Well-Known Member
Joined
Jan 1, 2020
Messages
2,873
Reaction score
5,911
Honestly, pull the float bowel and carb clean the needle and seat, and the main jet. The new gas sucks balls, but gets the varnish still that will stick the float.

About this time of year I end up doing a bunch of genny's...same people every year. They all say they'll start them every month...
Yeah I am going to pull it today I will post a pic of how it looks on the inside when I pull it off
 

ramos45

Well-Known Member
Joined
Jun 18, 2015
Messages
546
Reaction score
540
All these responses but still not one answer to your question, lol. :oops:
No need to replace right off the bat, you could remove it and clean it out with carb cleaner but since that requires removing anyways then feel free to replace with any carb that meets specs. I've had to clean out my Honda carbs when sitting too long. If you're lucky just remove the bowl and spray cleaner up from there.
 

Meaney77

Well-Known Member
Joined
Feb 25, 2009
Messages
7,680
Reaction score
8,294
I had a similar issue and dropped it off to a local lawn mower repair shop and they got it running like a raped ape again. Might be worth looking for a local shop.
 

BIGRED9158

Well-Known Member
Joined
Jan 1, 2020
Messages
2,873
Reaction score
5,911
I had a similar issue and dropped it off to a local lawn mower repair shop and they got it running like a raped ape again. Might be worth looking for a local shop.
What did you spend on it when you took it I mean a new carb is like 25 bucks shipped to my house on Amazon
 

Meaney77

Well-Known Member
Joined
Feb 25, 2009
Messages
7,680
Reaction score
8,294
What did you spend on it when you took it I mean a new carb is like 25 bucks shipped to my house on Amazon
I think it was around $50... I just figured it was easier to drop off and get fixed rather than ordering and returning parts and making trips back and forth to an auto part store. Thats usually my story when I dive into something!
 

yz450mm

Well-Known Member
Joined
Jun 10, 2013
Messages
3,579
Reaction score
7,195
What did you spend on it when you took it I mean a new carb is like 25 bucks shipped to my house on Amazon
I just put Amazon carbs on a Honda 185 ATC and a Foreman 500 quad, both fired right up and ran great. 25 bucks each, keep the old ones to use for spare Jets or parts if needed.
 

Your ad here

Well-Known Member
Joined
Oct 16, 2014
Messages
5,004
Reaction score
8,383
Before ordering a new carb try taking apart and rebuilding the one that's on it. Take lots of pictures of the throttle linkage and springs before you take it apart. If it runs with the choke on then dies when you turn the choke off more than likely the main jet is plugged.
 

Drew

Banned
Joined
Oct 13, 2015
Messages
850
Reaction score
1,969
Any time you use it , when done shut the fuel off and run it out of gas to keep the carb empty
 

BIGRED9158

Well-Known Member
Joined
Jan 1, 2020
Messages
2,873
Reaction score
5,911
Any time you use it , when done shut the fuel off and run it out of gas to keep the carb empty
Yeah I know that I have this thing for 5 years and this is the first time I forgot to do that
 

PlanB

Well-Known Member
Joined
Apr 25, 2018
Messages
4,882
Reaction score
10,292
I added petcocks to my Hondas. When I am done with them they all get stored dry. I drain the fuel tanks and run the carb dry.
 

mjc

Retired Neighbor
Joined
Jan 3, 2008
Messages
12,259
Reaction score
9,701
I have a honda 3000 and had the same problem. Since then I replaced the carb and now only use ethanol free gas in mine and run dry every time I test it. I read the ethanol was the problem but I think everyone knows that by now.
 

F.U.IRS

Well-Known Member
Joined
Jul 26, 2017
Messages
1,319
Reaction score
2,695
I put one of the cheap Amazon carbs on a 8750 Predator generator and it works great, easy install and only about $20. Bonus feature is automatic choke
 

C_J_J_C

Well-Known Member
Joined
Sep 16, 2021
Messages
856
Reaction score
2,687
Thanks for the reminder. I havn't started mine in a year. Battery was dead but fired right up with fresh gas and the pull start.
I always use fuel stabilizer and turn off the fuel and let it run dry.
 

~JM~

Well-Known Member
Joined
Sep 7, 2022
Messages
230
Reaction score
336
Add either Lucas Ethanol Treatment or Sea Foam to all your small engine fuel.

And don't forget that petcock thing....
 

D19

Well-Known Member
Joined
Aug 13, 2018
Messages
2,445
Reaction score
4,882
Not sure which model Gen I have but it has a B&S engine. It filled the engine with gas when I went to use it after it sat for years. Had to change the oil. Then I replaced my fuel lines and carb earlier this year with the Amazon one. Runs great. I go out to the shed and turn the key once in a while and let it run for a few mins. Fires right up.
 

Mike K

Well-Known Member
Joined
May 27, 2008
Messages
760
Reaction score
1,272
Here is the answer.
You can’t let it sit.
Its just like dirt bike … you gotta start them every month.
Sure you can run till it shuts off but ya gotta drain the bowl.
I know you’re not gonna do that … so figure outta a way to start it up every month.
I have paid $474 a year for so many years to clean the carb … all I gotta do is figure out how to get where it is every month .
I feel your pain.
 
Top