RiverDave
In it to win it
- Joined
- Sep 13, 2007
- Messages
- 126,591
- Reaction score
- 165,700
The term custom is thrown out a lot in this industry. To some manufacturers it’s actually gotten to the point of picking. Your colors on the same gel scheme they have done on the last ten boats..
I stopped by Concept Marine to check out a friend’s new build getting under way.
Before I get started I wanted to a second to point these out. These are mock up parts that were made via rapid prototyping. What that means is the parts were drawn in a 3D CAD software, the files were sent to a prototype house, the files are sliced and then parts were grown (not cut) layer by layer in a matter of hours to test fit, function.
This is what I used to sell for a living when I worked for Tbulger, with a variety of different processes.
I couldn’t hardly believe I saw RP arts at a boat shop!
The dash and v drive installation of this 21RC
As the boat comes together you will see this is going to Be a different style down pedal assembly / lock out then we have seen before.
This is the drivers sear base mock-up. The hole will be where there’d goes to run a cantileverto run the car hardware under the floor for the first couple feet until it goes to an open stringer boat.
Remember those prototypes? Look at what is on the outside of the stringer. Those are the real pieces installed. If you look across to the other stringer you can see they did a dual ram steering installation thruthestringer itself!
The beginnings if the passenger side foot hold
Its Ridiculously nice, but you don’t know the half of it! The plates, pillow blocks, backing plates are all made out of titanium!
I will keep this thread updated as progress is made. They will go a little f Rutherford before stopping and waiting for the ,Igor to rig the rest.
Concept Marine - 909 447 4411
I stopped by Concept Marine to check out a friend’s new build getting under way.
Before I get started I wanted to a second to point these out. These are mock up parts that were made via rapid prototyping. What that means is the parts were drawn in a 3D CAD software, the files were sent to a prototype house, the files are sliced and then parts were grown (not cut) layer by layer in a matter of hours to test fit, function.
This is what I used to sell for a living when I worked for Tbulger, with a variety of different processes.
I couldn’t hardly believe I saw RP arts at a boat shop!
The dash and v drive installation of this 21RC
As the boat comes together you will see this is going to Be a different style down pedal assembly / lock out then we have seen before.
This is the drivers sear base mock-up. The hole will be where there’d goes to run a cantileverto run the car hardware under the floor for the first couple feet until it goes to an open stringer boat.
Remember those prototypes? Look at what is on the outside of the stringer. Those are the real pieces installed. If you look across to the other stringer you can see they did a dual ram steering installation thruthestringer itself!
The beginnings if the passenger side foot hold
Its Ridiculously nice, but you don’t know the half of it! The plates, pillow blocks, backing plates are all made out of titanium!
I will keep this thread updated as progress is made. They will go a little f Rutherford before stopping and waiting for the ,Igor to rig the rest.
Concept Marine - 909 447 4411
