3D Printed Pole Support

[Toolman]

This is a portable cart that has a big monitor on top of the pole. When the cart is being moved around, the monitor bounces around too much and the customer asked us to come up with a solution. So the handrail for the cart seems to be very sturdy and I used it as a base. The clamp is easily removable without any tools.

 

[Icky]

I need a 3d printer

 

[renodaytona]

Pretty cool, 3D printers are such a rad tool. Did you think about if someone was to over tighten it and it breaks? Does it come with a warning or instructions?

 

[Toolman]

Yes, I had a meeting with the maintenance guy who’s in charge of taking care of these carts and showed him how tight to crank it, hence the really small knobs. I doubled the standard wall thickness on this job for extra strength and put radiuses and gussets everywhere I could.

 

[mattyc]

This is a portable cart that has a big monitor on top of the pole. When the cart is being moved around, the monitor bounces around too much and the customer asked us to come up with a solution. So the handrail for the cart seems to be very sturdy and I used it as a base. The clamp is easily removable without any tools. View attachment 1190739 View attachment 1190740 View attachment 1190741 View attachment 1190742 View attachment 1190743 View attachment 1190744 View attachment 1190745 View attachment 1190746 View attachment 1190747 View attachment 1190748 View attachment 1190749

Pretty slick! Those printers really open up a world of possibilities dont they

 

[Done-it-again]

Cool. What does the printer look like?

 

[Dog]

Lets see the printer. Those are relatively large parts it must be a pretty large printer.

 

[Toolman]

Creality 500mm cubed or about 20” cubed. You can still see the support structure on the table from the radius’s that go around the handle and the pole of the cart.

 

[Toolman]

Some printing pics.This was an earlier version print that bolted onto the cart instead of hinge bolts and knobs to make it removable without tools. The customer requested that it be put on and off the cart without tools.

 

[dspracing]

Nicely done. From the print quality I had assumed you were using some industrial quality printer. I see a lot of 3d printed stuff for sale online and it looks like junk but this came out really nice.

 

[lenmann]

Pretty damn cool!

I have been surprised at how tough the PLA material is. I have printed a handfull of little brackets and do-dads for my RZR that I figured would be temporary until I could fab something up in metal. After a year they are still holding up just fine so they are now permanent.

 

[Icky]

I'm surprised by how smooth the parts looks

 

[Done-it-again]

What program did you use to create the assembly?

 

[Toolman]

What program did you use to create the assembly?

Solidworks