2000 DCB Mach 26

[Nick0317]

2000 DCB Mach 26

TCM 600 with about 50 hours on it at this point. Just had service done at Octane Marine.

Bilge was done last summer with all new pumps and blower as well as fresh gel for a show finish.

IMCO SC upper was just serviced all new internals with about 18 hours on it.

IMCO SC lower with about 18 hours on it as well.

In Control foot throttle and controls

Livorsi nav lights

Isotta Zulga steering wheel

Tires were just installed last season

Hubs were just services and brakes

Extreme trailer with swing-away tongue. Updated LED lights all around.

Fusion stereo with driver controls


New interior just finished Aug. 2022 by Martinez Marine. Full custom build and not a reskin.

All new JL system 6 M6’s and 2 10’s with RGB freshly installed.

Flash interior LED lights hooked up to the JL controller

Storage under captains’ seats and glove boxes on the sides.

IMCO Dual ram hydraulic steering

Simrad Chartplotter

Full boat cover

New windscreens

Coolers were added in the floor.

Asking $80,000

Contact: 951-816-8759

 

[02HoWaRd26]

Was this boat wrapped? If it’s the one I’m thinking looks so much better without the wrap.

 

[LazyLavey]

Nice!!

GLWTS

 

[Nick0317]

Was this boat wrapped? If it’s the one I’m thinking looks so much better without the wrap.

This is not the boat that is wrapped. Yes, that guys boat looks way better unwrapped imho as well.

 

[eand28]

Nice float

 

[Nick0317]

Bump